• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Dave Neubert

  1. Dave Neubert

    #3406C low power

    3er01959 this is a high horse 525 hp in a drill rig motor bogs down under load. fuel pressure is 35- 40 psi under load, boost 15-17 psi replaced fuel lines,fuel filter, rebuilt injection pump no blow by on engine, any one have any ideas motor exhaust hardly smokes under load ,tried bi passing...
  2. Dave Neubert

    Splitting a cat 740b

    I did a Volvo with my 5,000 forklift
  3. Dave Neubert

    Old 1977 JCB 1400 Fuel issue

    Can't tell you how many calls i went to because someone put the seal in the filter and not the groove
  4. Dave Neubert

    CAT 345C Excessive vibration

    pull the case drain filter and look for Debrie
  5. Dave Neubert

    Volvo EC700B Boom lights quit

    Yes there should be a fuse or breaker. get a volt meter and trace the power to see where their is a open circuit
  6. Dave Neubert

    bobcat E 60, air condition system clicking and turning the clutch on and off

    low freon can cause this
  7. Dave Neubert

    D69U Fan Belt replacement

    I would think it would be better to and grill too
  8. Dave Neubert

    D6D LGP powershift, missing connection of air transfer tube from transmission to rear of torque converter

    Nige is correct if you don't replace the line at least put a breather of some sort on both sides there is no pressure or oil going thru it
  9. Dave Neubert

    Front driveshaft needed

    Iron peddlers has a lot of them parted out 704-289-8591
  10. Dave Neubert

    D7F Timing Injection Pump

    ok then do like TC says
  11. Dave Neubert

    D7F Timing Injection Pump

    you don't use the plate for this style. I use a drill bit in the timing hole
  12. Dave Neubert

    Building a Lake

    You need to stay away from this 955 it sounds like a money pit. I would get a d7 or d8 and a 615 pan to do what you need to do 200- 300 yards is a long way to push dirt
  13. Dave Neubert

    D4H stering break problem

    sounds like its time to pull finals,brakes,and steering clutches and rebuild
  14. Dave Neubert

    Help me diagnose my D6c final drive

    I would tear it down wile you can still save it
  15. Dave Neubert

    79U3437 D3 Dozer reinventing the wheel

    because you dont need 2800 psi to work clutches
See more
Top