• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Gary Morris

  1. G

    JD 9520

    It was incorrectly placed parking brake hoses.
  2. G

    CAT 349 BZ200804

    Have a machine that when at temperature and full idle will white stack like a train. Back it down to idle and its fine, there is emulsified oil gathering in the intake in cylinder head and the NRS cooler is wet inside . Any idea's?
  3. G

    JD 9520

    JD 9520 update. Called out local JD dealer and they got the tractor to move. We sent it out to work and it lasted an hour. new problem similar to last but no codes. If gear selector is in park all is well. As soon as you move out of park you get a noise from under the cab also, the steering...
  4. G

    JD 9520

    Sorry for late response. Only code is the seat code you referenced thx. I will check it in the a. M and update.
  5. G

    JD 9520

    RW9520E010119 and the code reads CCU 9. and then 6.2, thx.
  6. G

    JD 9520

    Have one of these and dropped the front axle to do bearings and seals. Put it all back in and went to operate machine and parking brake light is on in cab and it obviously won't engage gears. The panel is throwing a diagnostic code of CCU 9, or 9.62 or 96.2 or 962 or 9 and 6.2, hard to tell...
  7. G

    2002 Navistar 4300

    This engine keeps eating HPOP, three in the last 15 months, this last one lasted 500 miles after complete engine rebuild in a shop that I have never had any issue's with in 20 years. The last one was replaced under warranty by local International dealer after the new one they installed failed...
  8. G

    2016 Tigercat 620E Drive motor clutch

    Critical error message on display screen reads Drive Motor Clutch - slow response. Changed oil and filter in trans but at idle won't release parking brake, increase rpm and bump switch and brake will release and machine will move. Pulls hard in all gears and will keep moving at a snails pace...
  9. G

    TS14G'S

    Found it, thx for help.
  10. G

    TS14G'S

    No welding and will check cables again, thx.
  11. G

    TS14G'S

    Thanks all for response, the new ECU checks out fine and the old one had burnt out inner circuit board harness. Put new one on another machine and all was good so now that I have proved that out here is how we got there. Machine was fine, replaced drive shaft on front motor to trans and went...
  12. G

    TS14G'S

    TS14G with 5.9 Cummins blew ECU for front motor, replaced and still nothing. Thoughts please.
See more
Top