• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by ozarkag

  1. O

    Bobcat T770 aux no com and main no com codes

    If you have the aux no comm code, even if intermittent, that is a failing aux controller. Not so much logic or diagnosis as it's a case of a well known problem.
  2. O

    John Deere skid steers 331g

    2012 and "G" series doesn't jive About the only rebuilding will be o rings etc and control solenoids Is it leaking or acting up?
  3. O

    2008 Case 440CT-3 Skid Steer good or bad?

    Buttons on dash should scroll thru. Drive motor oil and condition
  4. O

    2001 bobcat g series 773 serial number 500k110873

    Try loosening the actuators a bit, then tighten evenly. It is possible to bind if one side is tightened too much. Also try to operate with the bolts just barely snug. It was working fine before you resealed? And when you calibrate, you can hear the actuators cycle, if you unlock without...
  5. O

    Mustang MTL16/Takeuchi TL130 Filter Parts Numbers?

    Definitely will be some serial break options. Engine oil, fuel, and possibly air will be available from all major brand's, Donaldson, Wix, Baldwin, Etc Hydraulic ones will most likely need to come a dealer.
  6. O

    Suggestions for first heavy equipment purchase

    And welcome to Missouri! Skid steers is what I do, but with that said, for a small property a compact tractor might fit the bill.
  7. O

    Looking for a service truck with a 14' body and 12k crane

    If you find that perfect rig but it's in the Midwest let me know. .. . That is about exactly what we are looking for.
  8. O

    Diagnostic tools

    Deere "should" sell you Service Advisor, be interesting to know their current stance with right to repair. Any Service Advisor from anywhere else will be hacked/ black market. Jaltest by Cojali does pretty good for a non oem software.
  9. O

    2014 Case SR250 'No Power to Display Panel'

    What KSSS said, Believe dash should beep and light up when seat switch is activated, even with key off.
  10. O

    Kubota SVL90-2 no power under load and producing black smoke under load.

    Thanks for coming back and posting that. Does look familiar. We have tried to come up with a better mount for the DPF/ muffler but hardly anywhere to bolt to. Did have one deleted one come thru where we simply removed the DPF entirely and installed a light muffler.
  11. O

    Bobcat 773 starter replacement

    Yup. Just trying to make sure the OP doesn't have the start wire on a misplaced R terminal, with the S terminal hidden on the back of the solenoid.
  12. O

    s250 low charge pressure

    So the lift/ tilt solenoid is the Bics solenoid? Single black coil in the middle of the valve Trying to follow here . . .
  13. O

    Bobcat 773 starter replacement

    And I've seen aftermarket starters with the R terminal on the opposite side from the original. ..
  14. O

    s250 low charge pressure

    By lift/ tilt solenoids are you referring referring to the 2 spool lock solenoids? These would have a stem that could have been cut off in an attempt to bypass the valve lockout.
  15. O

    Bobcat 773G

    So not unlocking at all, but has park solenoid and guts removed
Top