• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by ryan1239

  1. R

    259d shutdown

    DPF can was cleaned but nothing was reset from a software perspective.
  2. R

    259d shutdown

    Hoping you all can help. Have a recently rebuilt motor in a 259d. Unit will run for about 15 seconds and then shut down. I have a severity level 3 DPF warning from before motor was rebuilt. Would this cause a shutdown? Assuming I need the Software to clear that out. Thanks
  3. R

    Cat 259D wiring schematic?

    Have fuel to the rail. Noticed when Im cranking I have no engine RPM. Have a running 279d and when that gets cranked it registers at about 200rpm. Is the RPM taken off the crank, Cam or some other sensor.
  4. R

    Cat 259D wiring schematic?

    Motor was rebuilt and just installed. Hydraulic pump etc is not connected to motor. Motor cranks. Lift pump runs, but I need to test the flow and the duration. New fuel filter. Doesn't appear to be a line issue / plumbing. Not getting fuel to rail. If a sensor that was part of ECM circuit was...
  5. R

    Cat 259D wiring schematic?

    Looking for a wiring diagram for a 259d SN FTL08239. Is there any wiring going to injection pump that would keep motor from starting?
  6. R

    Cat 257d advanced display won’t work

    Has anyone found a place to repair the Advanced Display?
  7. R

    Cat 289D Wiring diagram

    PGTL01741
  8. R

    Cat 289D Wiring diagram

    I havea 2015 279d that has an advanced display issue. I do have power to the red wire on the harness going into the display. That mean the display is just bad?
See more
Top