• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

batteries

  1. A

    Ford E450 Bucket Truck (Roberts Hydraulic) – 12V or 24V System? Rewiring After Battery Fire

    Hey guys, looking for some experienced help on a bucket truck electrical setup. I bought a 2010 Ford E450 with a Roberts Hydraulic Lift. Batteries were dead when purchased. Unhooked batteries without marking each one ne where to be hooked back to. DUH IS ME lol I then had a battery fire, but...
  2. D

    Cat 259d low voltage

    I keep getting a low voltage message on machine replaced the battery message went away for couple days than came back, tested the battery it was good so replaced the alternator and voltage went back up to around 14.2v for about 2 days now its dropping below 11v with the error message and wont...
  3. TEX32

    Technician requires some insight ( Energized frame w/ batts off )

    Afternoon fellas. Licensed tech here ( 20 years ) Need a hand trying to figure this one out... Details: Cat 980G. 4 batteries, 2+2 set up, 24 volt system. ( obviously ) - When batteries ON, frame is grounded 100% - When batteries are shut off, frame energizes to 95% source voltage. ( 25.6...
    • TEX32
    • Thread
    • 24v 980g batteries disconnect electrical energized frame positive short voltage
    • Replies: 97
    • Forum: Tractor/Loader/Backhoes
Top