• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

help needed

  1. H

    JCB JS130 CAPS function for throttle reset - won't complete cycle

    Hello everyone, I've got a JCB JS130 excavator. Very similar to a case 9010B or linkbelt. Had some hydraulic pressure issues and decided to make sure I was getting full engine RPMs before I messed with the hydraulics too much. My local JCB dealer send me instructions on hot to reset the...
  2. M

    New (Used) Takeuchi TL8 - Forced Regen needed

    Hey Guys, I just got a used TL8, that needs a manual regen. It’s beeping every second and wants a parked regen, but when I go through the process to initiate it, it won’t start the regen. Previous version owner says it’s been sitting for about a year. It’s got an error code: SPN3701 FMI:16...
  3. T

    Case 850 D TCV Advice needed

    Good morning all, We recently purchased (And Received) a Case 850 D from an auction it starts and (Moved) just fine off of the trailer and around our lot. We were told the brakes needed service and that fluids and filters should be changed. A few days later we went to move it into our shop for...
  4. K

    TD15E

    I’m looking at possibility purchasing a TD15E. I’ve seen older post regarding parts availability. Is there anywhere to still get some parts. Also if the final drive is overfilled (I assume leaking from trans) is that a huge issue? Is there a way to check pivot shaft since that seems to be a...
  5. C

    IT28G Slow lowering hydraulics and cannot use joystick to lower mast

    Hello, i have an 03 IT28G with forks installed. The main lift cylinders will not lower unless manually powered (with a battery) at the solenoid on the manifold that is at the base of the cylinders. you only need to activate the right side for it to work because the left will do nothing. I have...
  6. J

    4239T low oil press need help

    rebuilt engine all new parts old block was shot got used block all parts sent to machine shop plastigaged everything good new oil pump 3 to 4lbs oil press at idle 15 lbs reved up . is there a plug missing that's dumping my oil ? any ideas would be appreciated
Top