• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

tb016

  1. J

    Winding ends fixings to rectifier

    Hello again. Trying to remove the rectifier I notice that the winding ends are not soldered as in all videos I've seen. They are just curled into a loop, bent flat, then screwed down. With the screws removed you can bend up the loops and the rectifier is ready to lift off. See yellow lines. Am I...
  2. J

    Removing engine cover/cowling

    My machine is a 2008 Takeuchi TB016 but interminable and fruitless exchanges with ChatGPT make me think there are perhaps principles that may apply to more than my machine. I've removed four obvious 17mm bolts from underneath, and two others that I happened to be able to see. I lot of...
  3. J

    TB016 not charging

    Hello, My machine is not showing increased voltage when the engine is running. The tension on the belt seems ok but to change it, it seems you have to lift off the canopy and remove half the machine to get access so I'm thinking of cutting out the side with ventilation slots (and later fitting...
    • Johnfused
    • Thread
    • cut open panel radiator removal tb016
    • Replies: 9
    • Forum: Excavators
  4. I

    TB016 Swivel joint removal is possible without removing the upper frame.

    I had searched to see if anyone had removed a swivel joint from a TB016 and only found 1 thread of someone even mentioning it. Manual says to pull the upper frame. It is doable but it is a major pain. Having stubby box wrenches will assist greatly along with universal joints and 3/8s extensions...
  5. P

    TAKEUCHI TB016 not charging

    Hi guys, I appreciate any help with my Takeuchi. The battery is not charging. I have already done to alternator replacement, but still no charge while the engine is running. Specs: Takeuchi TB016 year 2005 with Yanmar 3TNE68 engine. Alternator is the "dynamo type" (the slim one) According to...
    • proplan2
    • Thread
    • charging problems takeuchi tb016
    • Replies: 5
    • Forum: Excavators
  6. D

    Cross Reference Battery 2011 TB016

    Hey everyone - I picked up a used TB016 last year and everything was working great until recently went to start and the battery was toast. Looks to be the original battery with Japanese writing on it. Can anyone tell me a part number at Napa or somewhere else that’s a little more readily...
  7. A

    Takeuchi TB016 lost L.H. side controls

    Hi, I would be grateful if someone could help. As I was trying to hitch a bucket, I suddenly lost all left hand side controls. Every time I try to use the LH side lever the 10A fuse blows in the fuse box. I checked the stop (safety) switch under the Control Box and it works fine. By looking on...
    • Ari-
    • Thread
    • hydraulic valve solenoid left hand side controls lh lever losing controls takeuchi takeuchi electrics takeuchi hydraulics solenoid takeuchi wiring tb-016 tb016
    • Replies: 2
    • Forum: Excavators
Top