Cat D3C Series II Dozer Pin Slop

[PurpleCactus]

Hi All,

On the D3C Series II (1992 Model), CAT did not put any bushings where the pins attach to the blade. Is this suppose to be a tight or pressed fit?

What are the possible ways to fix the slope in the mount on the blade? All of my pins are like this.

 

[Tyler d4c]

Weld the holes up and make them the right size

 

[chidog]

How much clearance is there, I've seen way worse. Like said above weld a small amount then use a die type grinder to grind to the correct size. A very slight press fit is okay, not too much.