dieseldog5.9
Senior Member
Picked up an older Snap-on Plasma cutter years ago, seems to run fine right up to the point that it blows the breaker. Now my garage is fed off the panel in the house so not a big enough service for a plasma cutter.
Plan B run the plasma cutter off the Miller Trailblazer on the service truck, welder is a 4 prong plasma cutter is a 3, Made up an adapter from home depot parts, plugged it in plasma cutter had very little power, got frustrated and shoved it in the corner.
Is the adapter from Miller to go from 3 to 4 prong necessary, is their something special going on there that cant be replicated?
Is there a special setting on the welder to get full power out of the 4 prong outlet?
Plan B run the plasma cutter off the Miller Trailblazer on the service truck, welder is a 4 prong plasma cutter is a 3, Made up an adapter from home depot parts, plugged it in plasma cutter had very little power, got frustrated and shoved it in the corner.
Is the adapter from Miller to go from 3 to 4 prong necessary, is their something special going on there that cant be replicated?
Is there a special setting on the welder to get full power out of the 4 prong outlet?