The power bobtach on my S250 stopped working yesterday. I found the pins to be free and well lubed, checked all fuses, checked power to switch 14 volts, (while running) before rocking the bobtach switch I checked the two outgoing legs and they both have 6-8 volts on them, when I would rock the switch over to up or down the voltage would slowly climb up to 14 volts on the multi-meter. Also with the hoses removed from the bobtach cylinder I have no flow while rocking the switch.
The only way I have been able to switch attachments on the machine is to take off one hose and pull the manual levers up to disconnect, then put the hose back on, and hookup, and when I curl back the attachment the pins will go down and engage.
I pulled the spool valve out and checked it, it was clean and moved freely.
Any help in troubleshooting would be appreciated. Thanks.
The only way I have been able to switch attachments on the machine is to take off one hose and pull the manual levers up to disconnect, then put the hose back on, and hookup, and when I curl back the attachment the pins will go down and engage.
I pulled the spool valve out and checked it, it was clean and moved freely.
Any help in troubleshooting would be appreciated. Thanks.