Bootheal
Senior Member
I have a few of these concrete covered foam blocks that were the walkway at a marina. The original install used wire rope strung through the blocks to keep the dock ‘together’. I would like to remove the old cable as I probably need this to reassemble in another fashion.
I’m thinking of hooking a welder to the old cable in an attempt to heat the cable fairly hot.
Questions:
Will it damage the welder?
What amperage?
Time limit?
I know some welders have 20% duty cycles. Not sure what this one is but will find out. It’s an old Forney that you plug the leads in for different amperage.
thanks, Mike.
I’m thinking of hooking a welder to the old cable in an attempt to heat the cable fairly hot.
Questions:
Will it damage the welder?
What amperage?
Time limit?
I know some welders have 20% duty cycles. Not sure what this one is but will find out. It’s an old Forney that you plug the leads in for different amperage.
thanks, Mike.