• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by minerk

  1. M

    2020 Deere 333g hydraulic oil overheating

    Right, but is there any program where Deere is picking up the cost for the update? I've seen a few guys say the dealer/JD are doing this at no charge.
  2. M

    2020 Deere 333g hydraulic oil overheating

    I'm having issues with a 2019 331G also having high hyd temps alarms while running a Rut Terminator XP brush mower. This is a standard flow machine (SN 1T0331GKKKF363222), the mower is rated for 25 gpm. Engine coolant temps are fine, but after mowing for 45 minutes or so I'm at 221-226 degrees...
  3. M

    Deere 333G DEF fault codes

    Success! No codes in 45 minutes of brush mowing at full throttle! Can't thank you enough!
  4. M

    Deere 333G DEF fault codes

    You nailed it. Once I opened up the loom I could see the wires were both pretty badly crushed where the loom stopped. Red one was stretchy. Put just a little pressure on it and it snapped. Repaired the wires last night, going to test run today. Thanks again!
  5. M

    Deere 333G DEF fault codes

  6. M

    Deere 333G DEF fault codes

    Will get the pic this weekend. Thanks so much!
  7. M

    Deere 333G DEF fault codes

    It will throw that code every time within a few minutes if I throttle up beyond half throttle. At half throttle I can usually run for a while before it happens. It clears when I shut down. I also get the 523625.00 code, clears when I shut down.
  8. M

    Deere 333G DEF fault codes

    I'm having these same codes on my 331G, which is out of warranty. Can the harness be repaired? $2200 for a new harness.
  9. M

    Lady Marion on the move

    Replaced the.8050 drag gear case that this machine was built with (18"'wide bull gear and bolt down drum bearing carriers) with an 8200 type with the 23.5" wide bull gear and pin on bearing carriers. The case was built in the later Marion style with 4" thick case walls and 7" plate from the...
See more
Top