• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by tljohnson05

  1. T

    9560R Shut Down(s)

    Shutting down under operation. No Active Codes/Faults but only does it once it reaches operation temperature. I will return to it in the morning as it will be cold, so I plan on running key on/engine off test first, then fire her up and have it record data. The first few attempts it would not...
  2. T

    08 New Holland 110TL

    Thank you, after inspecting and test I did confirm leaking inner seal/wiper was bad on one and weak on the other.
  3. T

    Bobcat Comm Data Link & Cables??

    So I have a diagnostic laptop, which I use for Cummins, JD and Cat. I have the Nexiq 3 for a data link that runs most of them but have never ran the Bobcat Service Analyzer and I know I do not have the correct plug in's or communication link for Machine and or ECM. Any help will be much appreciated.
  4. T

    08 New Holland 110TL

    Has anyone had bucket arm lowering with and without load on its own while running? Any help would be greatly appreciated.
  5. T

    242d axle replacement

    Confirmed front right axle assy will need to be replaced on wheeled unit, I have the axle assy and o-rings on hand. Any tips for removal and re-installation?
  6. T

    Kubota SVL 95-2 Seat Switch Replacement

    Has anyone had to replace the seat pressure switch, if so I am assuming you have to remove the seat from the cab? Any points of direction is appreciated.
  7. T

    Caterpillar D4H low power smoking black

    Would start simple with fuel filters, and make sure if its equipped with a waste gate on turbo its operational.
  8. T

    D5G Speed Control Issues

    well turns out the rats built a nest with thorns and sticks, three wires got to be apart of the habitat. Repaired wires, cleared codes in log, calibrated and tested. All issues fixed = I got lucky. Chrisso and CM, the log is where i found the high and low voltage alarms that made me look at...
  9. T

    D5G Speed Control Issues

    Thank guys, I will let you know what I find.
  10. T

    D5G Speed Control Issues

    That would be awesome. I was hoping when the time zone rolls around, someone would reply. CAT00D5GLWGB02776
  11. T

    D5G Speed Control Issues

    Yes I do, and no on the log as I didn't have the time but I will in a few hrs while onsite. No events either which was really odd too. Once i gain access to soleniods I hope that I have the fittings to run pressure test as well if it comes to it. But the real time log should show where to look...
  12. T

    D5G Speed Control Issues

    D5G operates just fine but will go into a limp mode if you will intermittently. The (speed control) is on the left joystick push buttons, and is responsive to command to dash. It only did it once while I was there. This issue is Interment to say the least, as the operator used it for a 2hrs...
See more
Top