Bobcat s150 12-22 code

[Gwilkrrs]

Got the general warning diamond and the 12-22 code for right aux

I guess I will tilt cab again and check wires - replacing the handle in its entirety is $$$$

I hope the diamond warning is for this- I don’t remember this last time I just remember the 2 beeps so I am wondering if the diamond is for something else

 

[Bloody Knuckles]

The diamond should be for a warning as the system does a self check on startup and will list the 1st error that comes up.
Disconnect your battery, check the wiring from the handle to the controller by taking the handle apart and dissconecting the hall switch wiring 3 wire plug. ( You can also use a paper clip in the back of the plug if you don't want to take it apart ) Find J1 on the controller, disconnect it. Take a omh reading and see if you have continunity for the 3 hall switch wires. They should be numbered. Also check it while the lever is being moved. If that checks ok then it's the hall switch. Hall switches can be checked but that's another story. If you replace the hall switch it then needs to be calibrated. If you have a service manual it explains the procedure. If you're NOT comfortable doing this procedure,... take it to someone or your dealer.

 

[Gwilkrrs]

Hmmmm how do I figure out what the warning is for?
The 12-22 may be a little above me unfortunately-
Is there danger to running it without repair for this for a bit?

 

[Bloody Knuckles]

"The diamond should be for a warning as the system does a self check on startup and will list the 1st error that comes up."
If that's the only code and if it starts and moves then more than likely you can use it ( Just not the aux control ) It also could be something as simple as a bad ground. Bad grounds can do some strange things....

 

[Gwilkrrs]

I am going to tilt the cab and check the wires

recently had to trace a wire for a no start the just fixed a hydro leak so I guess I will try to look for the wire here-

thanks

 

[Tinkerer]

From the S150 Operation and Maintenance Manual.

 

[Gwilkrrs]

Thanks
Ran the machine for 2 hours off and on today and never beeped with the code so I should try to trace wires—

 

[Gwilkrrs]

So I checked wires and couldn’t find anything
While using the grapple the 12-22 and 12-23 codes came and interfered with the aux functions of the grapple
Man the new right controller is expensive……..

 

[Txhayseed]

Hand and foot control ?? If so check the wires where they come out the handle tube and into the weather pack connectors. You can unplug the connection, take your meter and check continuity for the rocker. If its good at the plug then plug the connection back in and back probe the connection machine side and repeat test. If its good go to valve body and test at coil. If its not good at control arm side at the plug no continuity then its the switch itself. They are potted switches so the assembly has to replaced.or you can take the cheaper option and add your own button. Tap the wires at the connection. But if it the switch highly recommend just replacing the assembly. Or getting your dremmel out and removing all the potting compond and getting a rocker to make work. But thats a ruff road to hoe. I tried it once for giggles to try.

 

[Gwilkrrs]

yes hand and foot controlled
ok will try that this weekend
thanks