Hello, I bought this machine Case Backhoe 680G a few years ago. I have only good things to say about it. I got this machine to do some work around my farm roads, building, garden, etc. The digger in my machine has a digging bucket so it has teeth but the front end bucket has no teeth. I have been looking I around to try to find teeth to put on the front end bucket but I have no luck yet. It does not seem as straight forward to find the right teeth. Would someone be so kind to give me some advise on how to find these teeth. Or if someone knows exactly where to get this teeth the parts and all it would be very much appreciated. Thanks.
-
Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!
Case Backhoe 680G front bucket teeth
- Thread starter Edc
- Start date
Or,
This is what Case would put on it at the factory .
Hopefully your cutting edge has the holes in it for the shanks.
There are aftermarket substitutes available for it.
https://www.mycnhistore.com/us/en/c...56875BD6/4AD26496-EFBE-E111-9FCE-005056875BD6
This is what Case would put on it at the factory .
Hopefully your cutting edge has the holes in it for the shanks.
There are aftermarket substitutes available for it.
https://www.mycnhistore.com/us/en/c...56875BD6/4AD26496-EFBE-E111-9FCE-005056875BD6
Thank you for the replies. My cutting edge has only one square hole every foot or so and the shank in the picture has two holes. So I think the tooth bar will be a better choice. I might have to make my own. It is hard to find the size that will fit my bucket. Thanks again.
gggraham
Senior Member
- Joined
- Feb 13, 2009
- Messages
- 641
- Location
- London Ontario Canada
- Occupation
- Licensed Heavy Duty Equipment Mechanic
If you want teeth welded on or need the shanks and teeth to make a tooth bar they are just 230 teeth and the shank is a 1001-23. See attached pictures. The 230 teeth are still used on Case backhoe buckets. The shanks are slightly different than on a backhoe bucket as to keep the teeth parallel with the ground. I am in London Ont. if you are close I can supply the teeth and shanks to you. 
