Georgia Iron
Senior Member
- Joined
- May 6, 2012
- Messages
- 887
- Location
- USA - Georgia
- Occupation
- Concrete building slab and grading contractor
I purchased a used Case CX160. Sserial number 160k3-1264
I have bought the service and parts manual and I am trying to figure out what lines need to be swapped around to convert the digger pattern. Can you guys point me in the right direction. I am not seeing what I need in the service manual.
The manual shows a part called a pilot function block, a swing shuttle block, servo control and return manifold block. But no hoses are identified.
Ok I found a control pattern modification.
I have bought the service and parts manual and I am trying to figure out what lines need to be swapped around to convert the digger pattern. Can you guys point me in the right direction. I am not seeing what I need in the service manual.
The manual shows a part called a pilot function block, a swing shuttle block, servo control and return manifold block. But no hoses are identified.
Ok I found a control pattern modification.
Last edited: