Volvo ew180b error codes

[ROAMER_AUS]

Hi all,

I have EW180B bogging down, engine RPM drop and sometimes shuts down when loaded.
Error codes that it comes up with:
130 SID 254 13
130 PPID 1193 12
I can't find anything on these error codes.
Any help would be greatly aprecciated!
Also I am looking to purchase a service manual for this machine if anyone can point me in the right direction.

Thanks!!!

 

[uffex]

Good day
I believe the first notation is that of a transmission ECU fault I attach the second.
Kind regards
Uffex

 

[ROAMER_AUS]

Thanks for the info uffex!!! I managed to get codes decoded elswhere also. Now must be broken wire somewhere. Does anybody have a diagram where is this solenoid connected to? I mean what pins of the computer. It is impossible for me to trace it due to layout of the excavator. Also, resistance value of the solenoid?
Thanks!!!

 

[uffex]

Good day
Here is some information may be of help.
Kind regards
Uffex

 

[ROAMER_AUS]

Great help uffex!!! Thanks!!!

 

[Kemper]

Hello, I have code 130 ppid 1288 12 and cannot find anything as to what this codes means any help would be appreciated

Good day
Here is some information may be of help.
Kind regards
Uffex

 

[uffex]

Good day
We are talking transmission error, see attached
Kind regards
Uffex

 

[Kemper]

Good day
We are talking transmission error, see attached
Kind regards
Uffex
View attachment 272077

Thank you! Where abouts would I find the sensor on transmission area? Above?

 

[Kemper]

Good day
We are talking transmission error, see attached
Kind regards
Uffex
View attachment 272077

Would this be the right area? And would the solenoid to the far left be the one in question

 

[Kemper]

Would this be the right area? And would the solenoid to the far left be the one in question

Pictures to go with this

 

[uffex]

Good day Kemper
MA4202 is the high low speed solenoid see attached, there are a number of diodes need checking out.
Kind regards
Uffex

 

[Kemper]

Good day Kemper
MA4202 is the high low speed solenoid see attached, there are a number of diodes need checking out.
Kind regards
Uffex

So I have voltage to sensor 3 but when I check resistance on sensor I get o/l which I take as bad ?

 

[Kemper]

For m2402 should I have constant 24v to sensor?

Good day Kemper
MA4202 is the high low speed solenoid see attached, there are a number of diodes need checking out.
Kind regards
Uffex

 

[Kemper]

So found the sensor for m2404 open, where others were around 26-30 ohms, I swapped sensors and problem followed to another.

 

[uffex]

Good day Kemper
Am I interpreting your post correctly that you have located the issue to the solenoid coil ?
Kind regards
Uffex

 

[Kemper]

Now have code 130 ppid 1092 1 what would that relate as in park break

 

[uffex]

Good day Kemper
See attached
Kind regards
Uffex

 

[RainerJR]

Hi, can you tell me witch solenoid controls the oil flow to the parking brake system?
MA5501 as i can see from the wiring diagram...

Rainer

 

[uffex]

Good day
See attached.
Kind regards
Uffex

 

[RainerJR]

Good day
See attached.
Kind regards
Uffex

Big thanks!