Hi all
I’ve been asked to check out a 140 G as i was in the area (remote west qld) doing some other jobs
So the story goes it had blown the hydraulic pump was taken to a shop for fixing and they couldn’t get a cat pump so an ITR was fitted and they have had trouble setting things up
So i have very little steering (won’t turn on the ground)
I have a pressure gauge on distribution valve ( as it sends oil to both control banks for lift extra)
So LH bank seems to function fine but the left is all over the place artic has limited push , blade lift is now better but can change to no lift on next pull of lever
It seems like a relief valve or sensor line is not working
Have been into cat sis and there is no information as to how to setup a hydraulic pump
Any help would be appreciated by the owner
I’ve been asked to check out a 140 G as i was in the area (remote west qld) doing some other jobs
So the story goes it had blown the hydraulic pump was taken to a shop for fixing and they couldn’t get a cat pump so an ITR was fitted and they have had trouble setting things up
So i have very little steering (won’t turn on the ground)
I have a pressure gauge on distribution valve ( as it sends oil to both control banks for lift extra)
So LH bank seems to function fine but the left is all over the place artic has limited push , blade lift is now better but can change to no lift on next pull of lever
It seems like a relief valve or sensor line is not working
Have been into cat sis and there is no information as to how to setup a hydraulic pump
Any help would be appreciated by the owner