joelx777
Well-Known Member
Okay, I went out and ran the machine today. Sure enough, once it was warm the boom down pressure would not build beyond 2000, it should go up to 5200.
I took off the cover on the boom down circuit pressure relief valve, and turned the adjustment screw the equivalent of 3200 PSI up. Once the machine warmed up again, it would not go above 2,000 PSI like before. I'm trying to remove the pressure relief valve, but it's on there super tight and I can't get any leverage. Here's what it looks like -
https://photos.app.goo.gl/RJ6ZPdRcYwSDUzvJ7
My intention once I get it off is to take it apart, inspect it for damage and if there's not any, replace the o-rings and try again. If there is damage, I will buy a new one.
I took off the cover on the boom down circuit pressure relief valve, and turned the adjustment screw the equivalent of 3200 PSI up. Once the machine warmed up again, it would not go above 2,000 PSI like before. I'm trying to remove the pressure relief valve, but it's on there super tight and I can't get any leverage. Here's what it looks like -
https://photos.app.goo.gl/RJ6ZPdRcYwSDUzvJ7
My intention once I get it off is to take it apart, inspect it for damage and if there's not any, replace the o-rings and try again. If there is damage, I will buy a new one.